Nortel BCM 3.7 Manual page 924

924 R
recall
See Link.
receiver
In this document, this term can refer to the handset of a telephone.
regression code
This feature restores the previous system security number so that previously applied
UTAM Activation Codes and Portable Credit Codes can be re-entered to restore full
system operation for Companion components. Also required in cases of system recovery.
You cannot use this code again.
relaying
Relaying is the process of moving data along a path determined by a routing process. The
data is relayed between a source and a destination.
remind delay
A feature, referred to as held line reminder, causes a telephone to beep and display the
message On hold: LINENAM when a call has been on hold for a programmable period
of time. Turn the feature on and set the timing under Feature settings. (Services,
Telephony Services, General settings)
remote access
The ability to dial into a Business Communications Manager system from outside the
system and use selected features. The Class of Service determines which lines, features,
and dialing capabilities are available.
In private networking, this term refers to one system accessing another system over a
private trunk, for instance, for centralized voice mail. In this case, even though the number
is dialed over a private trunk, and the dialing plan may be set up so that the user dials the
same number of digits as for an internal call, routing is set up to dial out of the current
system and into or through the connected system.
remote access dial restriction
See restriction filters.
remote access packages
A restriction filter that is applied to an incoming line to control which digits are dialed
during an incoming remote access call. Remote access packages are defined under Remote
Access packages (Services, Telephony Services, General Settings), and assigned under
COS Passwords (Services, Telephony Services, General Settings)
remote access service
See RAS.
N0008589 3.3