Configuring Mld Snooping Querier - Dell PowerEdge M420 Configuration Manual

Command
ipv6 mld snooping
vlan-id
maxresponse
seconds
ipv6 mld snooping fast-
vlan-id
leave
ipv6 mld snooping
mcrtexpiretime
seconds
CTRL + Z
show ipv6 mld snooping
vlan-id
vlan

Configuring MLD Snooping Querier

Beginning in Privileged EXEC mode, use the following commands to
configure MLD snooping querier settings on the switch and on VLANs.
Command
configure
ipv6 mld snooping
querier
vlan database
ipv6 mld snooping
vlan-id
querier
ipv6-address
]
760
Configuring L2 Multicast Features
Purpose
Specify the leave time-out value for the VLAN. If an MLD
report for a multicast group is not received within the
number of seconds configured with this command after
an MLD leave was received from a specific interface, the
current VLAN is deleted from the member list of that
multicast group.
Enables MLD snooping fast-leave mode on the specified
VLAN. Enabling fast-leave allows the switch to
immediately remove the layer 2 LAN interface from its
forwarding table entry upon receiving an MLD leave
message for that multicast group without first sending out
MAC-based general queries to the interface.
Specify the multicast router time-out value for to
vlan-id
associate with a VLAN. This command sets the number of
seconds to wait to age out an automatically-learned
multicast router port.
Exit to Privileged EXEC mode.
View the MLD snooping settings on the VLAN.
Purpose
Enter global configuration mode.
Enable the MLD snooping querier on the switch.
Enter VLAN Configuration mode
Enable the MLD snooping querier on VLAN specified
[address with the
Use the optional
address that the snooping querier switch should use as the
source address when generating periodic queries.
vlan-id
parameter.
ip-address
parameter to specify the IP