Dell PowerEdge M420 Configuration Manual page 567

Command
(Continued)
interface
interface
name
ipv6 traffic-filter
direction
[sequence
num
]
Purpose
destination ipv6 prefix
•
address format.
• flow label
field of the IPv6 header (Range 0–1048575).
dscp
• dscp
depending on a match of DSCP values using the
parameter dscp.
• log — Specifies that this rule is to be logged.
time-range-name
•
associate with the ACL rule.
• assign-queue
queue for handling traffic that matches the rule.
interface
• mirror
to be copied to the specified interface.
interface
• redirect
matching this rule to be forwarded to the specified
interface.
(Optional) Enter interface configuration mode for the
specified interface. The
interface type and number, for example gigabitethernet
1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
Bind the specified IPv6 ACL to an interface.
seq-
NOTE:
To apply this ACL to all interfaces, issue the command
in Global Configuration mode.
name
• — Access list name. (Range: Valid IPv6 access-list
name up to 31 characters in length)
direction
• — Direction of the ACL. (Range: In or out.
Default is
seqnum
• — Precedence for this interface and direction. A
lower sequence number has higher precedence. Range: 1
– 4294967295. Default is1.
— IPv6 prefix in IPv6 global
value
— The value to match in the Flow Label
— Specifies the TOS for an IPv6 ACL rule
— Specifies the named time range to
queue-id
— Specifies particular hardware
— Allows the traffic matching this rule
— This parameter allows the traffic
interface
in
.)
Configuring Access Control Lists
variable includes the
567