Configuring Lacp Parameters - Dell PowerEdge M420 Configuration Manual

Configuring LACP Parameters

Beginning in Privileged EXEC mode, use the following commands to
configure system and per-port LACP parameters.
Command
configure
lacp system-priority
value
interface port-channel
number
lacp port-priority
lacp timeout {long |
short}
exit
interface
show lacp
Purpose
Enter global configuration mode.
Set the Link Aggregation Control Protocol priority for the
switch. the priority value range is 1–65535.
Enter interface configuration mode for the specified LAG.
You can also specify a range of LAGs to configure with the
interface range port-channel command, for example,
interface range port-channel 1-3,10 configures LAGs 1, 2,
3, and 10.
value
Set the Link Aggregation Control Protocol priority for the
port or range of ports. The priority value range is 1–65535.
Specify whether to wait a long or short time between
LACP PDU transmissions.
Exit to Privileged EXEC mode.
View LACP parameters for an Ethernet interface or a LAG.
interface
The
(gigabitethernet, tengigabitethernet, or port-channel)
and number.
parameter includes the interface type
Configuring Link Aggregation
843