Configuring VRRP Features (CLI)
This section provides information about the commands you use to configure
VRRP settings on the switch. For more information about the commands, see
PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide
Configuring VRRP Settings
Beginning in Privileged EXEC mode, use the following commands to
configure switch and interface VRRP settings. This set of commands also
describes how to configure VRRP interface and route tracking.
Enter global configuration mode.
Enable the administrative mode of VRRP for the router
Enter Interface Configuration mode for the specified
Allow the interface to create in the VRRP group specified
parameter, which is a number from 1–255.
(Optional) Create a text description that identifies the
Enable the preemption mode value for the virtual router
configured on a specified interface.
You can optionally configure a preempt delay, which is the
number of seconds the VRRP router waits before the
VRRP router sends an advertisement to claim master
Allow the VRRP Master to accept ping packets sent to one
of the virtual router's IP addresses.
Set the priority value for the virtual router configured on
Set the virtual router IP address value for an interface.