Configuring Dot1Ag (Cli); Configuring Dot1Ag Global Settings And Creating Domains - Dell PowerEdge M420 Configuration Manual

Configuring Dot1ag (CLI)

This section provides information about the commands you use to configure
Dot1ag settings on the switch. For more information about the commands,
PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide
see the
at support.dell.com/manuals.

Configuring Dot1ag Global Settings and Creating Domains

Beginning in Privileged Exec mode, use the following commands to configure
CFM settings and to view global status and domain information.
CLI Command
configure
ethernet cfm enable
ethernet cfm mep archive-
time
hold-time
ethernet cfm cc level
vlan-id
interval {1 | 10 | 60 |
600}
ethernet cfm domain
level
level
name
service vlan
exit
show ethernet cfm domain
brief
Description
Enter global configuration mode.
Enables connectivity fault management services.
Set the time interval (range: 1–65535 seconds) after
which inactive RMEPs are removed.
level
vlan Configure the Continuity Check Message (CCM)
transmit interval for the specified VLAN.
name
Create a maintenance domain (MD) by assigning a
name and level (0–7), and enter Maintenance
Domain Config mode for that MD.
vlan-id
Create a maintenance association (MA) within the
current MD by associating it with a VLAN and
naming the association (as a service instance).
Exit to privileged Exec Mode
Display the configured parameters in the
Maintenance Domain.
Configuring Connectivity Fault Management
785