Configuring Mld Snooping - Dell PowerEdge M420 Configuration Manual

Command
ip igmp snooping querier
election participate
id
CTRL + Z
show ip igmp snooping
querier [detail |vlan
vlan-id
]

Configuring MLD Snooping

Beginning in Privileged EXEC mode, use the following commands to
configure MLD snooping settings on the switch, ports, and LAGs.
Command
configure
ipv6 mld snooping
interface
interface
ipv6 mld snooping
ipv6 mld snooping
groupmembership-
seconds
interval
758
Configuring L2 Multicast Features
Purpose
Allow the IGMP snooping querier to participate in the
vlan-
querier election process when it discovers the presence of
another querier in the VLAN. When this mode is enabled,
if the snooping querier finds that the other querier source
address is more than the snooping querier address, it stops
sending periodic queries. If the snooping querier wins the
election, then it continues sending periodic queries.
Exit to Privileged EXEC mode.
View IGMP snooping querier settings configured on the
switch, on all VLANs, or on the specified VLAN.
Purpose
Enter global configuration mode.
Enable MLD snooping on the switch.
Enter interface configuration mode for the specified port
or LAG. The
and number, for example gigabitethernet 1/0/3. For a
LAG, the interface type is port-channel.
You can also specify a range of ports with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
Enable MLD snooping (auto-learn) on the interface.
Specify the host time-out value for the interface. If an
MLD report for a multicast group is not received in the
number of seconds specified by the
interface is deleted from the member list of that multicast
group.
interface
variable includes the interface type
seconds
value, this