Default Ipv6 Routing Values - Dell PowerEdge M420 Configuration Manual

Next hop addresses computed by routing protocols are usually link-local.
During a transition period, a global IPv6 Internet backbone may not be
available. One transition mechanism is to tunnel IPv6 packets inside IPv4 to
reach remote IPv6 islands. When a packet is sent over such a link, it is
encapsulated in IPv4 in order to traverse an IPv4 network and has the IPv4
headers removed at the other end of the tunnel.Should I move SDM
template info to one of the chapters in the System section, like the
"Managing System Information and System Time" chapter? Other ideas?

Default IPv6 Routing Values

IPv6 is disabled by default on the switch and on all interfaces.
Table 37-1 shows the default values for the IP routing features this chapter
describes.
Table 37-1. IPv6 Routing Defaults
Parameter
IPv6 Unicast Routing Mode
IPv6 Hop Limit
ICMPv6 Rate Limit Error Interval
ICMPv6 Rate Limit Burst Size
Interface IPv6 Mode
IPv6 Router Route Preferences
Default Value
Disabled
Unconfigured
1000 milliseconds
100
Disabled
Local—0
Static—1
OSPFv3 Intra—110
OSPFv3 Inter—110
OSPFv3 External—110
Configuring IPv6 Routing
1059