Configuring An Ospfv3 Area Range - Dell PowerEdge M420 Configuration Manual

Configuring an OSPFv3 Area Range

Beginning in Privileged EXEC mode, use the following commands to
configure an OSPFv3 area range.
Command
configure
ipv6 router ospf
area-id
area range
prefix/prefix-length
{summarylink |
nssaexternallink}
[advertise |not-advertise]
exit
exit
show ipv6 ospf range
id
1000
Configuring OSPF and OSPFv3
Purpose
Enter global configuration mode.
Enter OSPFv3 configuration mode.
ipv6-
Configure a summary prefix for routes learned in a given
area.
area-id
•
(Range: IP address or decimal from 0–4294967295)
ipv6-prefix/prefix-length
•
length.
• summarylink — Specifies a summary link LSDB type.
• nssaexternallink — Specifies an NSSA external link
LSDB type.
• advertise — Advertisement of the area range.
• not-advertise — Suppresses advertisement of the area
range.
Exit to Global Config mode.
Exit to Privileged EXEC mode.
area-
View information about the area ranges for the specified
area-id.
— Identifies the OSPFv3 NSSA to configure.
— IPv6 address and prefix