Configuring Igmp Snooping Querier - Dell PowerEdge M420 Configuration Manual

Command
CTRL + Z
show ip igmp snooping
vlan-id
vlan

Configuring IGMP Snooping Querier

Beginning in Privileged EXEC mode, use the following commands to
configure IGMP snooping querier settings on the switch and on VLANs.
Command
configure
ip igmp snooping querier
vlan-id
[vlan ] [address
ip-address
]
ip igmp snooping querier
interval-
query-interval
count
ip igmp snooping querier
seconds
timer expiry
ip igmp snooping querier
version
version
vlan database
ip igmp snooping querier
vlan-id
Purpose
Exit to Privileged EXEC mode.
View the IGMP snooping settings on the VLAN.
Purpose
Enter global configuration mode.
Enable the IGMP snooping querier on the switch or on
the VLAN specified with the
ip-address
Use the optional
address that the snooping querier switch should use as the
source address when generating periodic queries.
Set the IGMP snooping querier query interval time, which
is the amount of time in seconds that the switch waits
before sending another periodic query. The range is
1–1800 seconds.
Set the IGMP snooping querier timer expiration period.
This is the time period, in seconds, that the switch
remains in non-querier mode after it has discovered that
there is a multicast querier in the network.
Set the IGMP version of the query that the switch sends
version
periodically. The
Enter VLAN Configuration mode.
Enable the IGMP snooping querier on the specified
VLAN.
Configuring L2 Multicast Features
vlan-id
parameter.
parameter to specify the IP
range is 1–2.
757