Configuring Ospf Interface Settings - Dell PowerEdge M420 Configuration Manual

Command
passive-interface default Configure OSPF interfaces as passive by default.
delay-time
timers spf
hold-time
exit
exit
show ip ospf
show ip ospf statistics
clear ip ospf
[{configuration |
redistribution | counters
| neighbor [interface vlan
vlan-id neighbor-id
[

Configuring OSPF Interface Settings

Beginning in Privileged EXEC mode, use the following commands to
configure per-interface OSPF settings.
Command
configure
vlan-id
interface vlan
Purpose
This command overrides any interface-level passive mode
settings.OSPF does not form adjacencies on passive
interfaces but does advertise attached networks as stub
networks.
Specify the SPF delay and hold time.
delay-time
•
hold-time
•
Exit to Global Configuration mode.
Exit to Privileged EXEC mode.
View OSPF global configuration and status.
View OSPF routing table calculation statistics.
Reset specific OSPF states. If no parameters are specified,
OSPF is disabled and then re-enabled.
]]}]
Purpose
Enter global configuration mode.
Enter Interface Configuration mode for the specified
VLAN.
— SPF delay time. (Range: 0–65535 seconds)
— SPF hold time. (Range: 0–65535 seconds)
Configuring OSPF and OSPFv3
983