Configuring And Viewing Pim-Dm For Ipv4 Multicast Routing - Dell PowerEdge M420 Configuration Manual

Command
show ipv6 mld-proxy
show ipv6 mld-proxy interface
show ipv6 mld-proxy groups

Configuring and Viewing PIM-DM for IPv4 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to
configure PIM-DM for IPv4 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-DM information.
Command
configure
ip pim dense
vlan-id
interface vlan
ip pim
ip pim hello-interval
exit
show ip pim
show ip pim interface vlan
vlan-id
show ip pim neighbor
vlan-id
[interface vlan
Purpose
View a summary of the host interface status
parameters.
View a detailed list of the host interface status
parameters. This command displays information
only when MLD Proxy is operational.
View a table of information about multicast
groups that MLD Proxy reported. This command
displays information only when MLD Proxy is
operational.
Purpose
Enter global configuration mode.
Enable PIM-DM on the switch.
Enter Interface Configuration mode for the specified
VLAN.
Enable PIM-DM on the interface.
seconds
Specify the number of seconds (range: 0–65535) to
wait between sending PIM hello messages on the
interface.
Exit to Privileged EXEC mode.
View system-wide PIM information.
View the PIM-DM information for the specified
interface.
View a summary or all the details of the multicast
| all] table.
Managing IPv4 and IPv6 Multicast
1215