Configuring Mld Snooping Querier - Dell PowerConnect 8024 User Configuration Manual

Command
ipv6 mld snooping vlan
vlan-id
immediate-leave
ipv6 mld snooping vlan
vlan-id
mcrtexpiretime
seconds
CTRL + Z
show ipv6 mld snooping
vlan-id
vlan

Configuring MLD Snooping Querier

Beginning in Privileged EXEC mode, use the following commands to
configure MLD snooping querier settings on the switch and on VLANs.
Command
configure
ipv6 mld snooping
querier
ipv6 mld snooping
vlan-id
querier vlan
ipv6-address
[address
744
Configuring L2 Multicast Features
Purpose
Enables MLD snooping immediate-leave mode on the
specified VLAN. Enabling immediate-leave allows the
switch to immediately remove the layer 2 LAN interface
from its forwarding table entry upon receiving an MLD
leave message for that multicast group without first
sending out MAC-based general queries to the interface.
Specify the multicast router time-out value for to
associate with a VLAN. This command sets the number of
seconds to wait to age out an automatically-learned
multicast router port.
Exit to Privileged EXEC mode.
View the MLD snooping settings on the VLAN.
Purpose
Enter global configuration mode.
Enable the MLD snooping querier on the switch.
Enable the MLD snooping querier on VLAN specified
vlan-id
with the
]
Use the optional
address that the snooping querier switch should use as the
source address when generating periodic queries.
parameter.
ip-address
parameter to specify the IP