Configuring A Port In General Mode - Dell PowerEdge M420 Configuration Manual

Configuring a Port in General Mode

Beginning in Privileged EXEC mode, use the following commands to
configure an interface with full 802.1q support and configure the VLAN
membership information for the interface.
Command
configure
interface
interface
switchport mode general Configure the interface as an untagged layer 2 VLAN
switchport general
allowed vlan
vlan-list
[add|remove]
{tagged|untagged}
switchport general pvid
vlan-id
608
Configuring VLANs
Purpose
Enter global configuration mode.
Enter interface configuration mode for the specified
interface
interface. The
and number, for example gigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
interface.
Configure the VLAN membership for the port. You can
also use this command to change the egress tagging for
packets without changing the VLAN assignment.
vlan-list
• add — List of VLAN IDs to add. Separate
nonconsecutive VLAN IDs with a comma and no spaces.
Use a hyphen to designate a range of IDs. (Range:
1–4093)
vlan-list
• remove
nonconsecutive VLAN IDs with a comma and no spaces.
Use a hyphen to designate a range of IDs.
• tagged — Sets the port to transmit tagged packets for the
VLANs. If the port is added to a VLAN without specifying
tagged or untagged, the default is untagged.
• untagged — Sets the port to transmit untagged packets
for the VLANs.
(Optional) Set the port VLAN ID. Untagged traffic that
enters the switch through this port is tagged with the
PVID.
vlan-id
— PVID. The VLAN ID may mot belong to a
VLAN that does not exist on the switch. (Range: 1–4093)
variable includes the interface type
— List of VLAN IDs to remove. Separate