Configuring Igmp Snooping On Vlans - Dell PowerEdge M420 Configuration Manual

Command
CTRL + Z
show ip igmp snooping
show ip igmp snooping
interface
interface

Configuring IGMP Snooping on VLANs

Beginning in Privileged EXEC mode, use the following commands to
configure IGMP snooping settings on VLANs.
Command
configure
vlan database
ip igmp snooping
ip igmp snooping
groupmembership-
vlan-id seconds
interval
ip igmp snooping
vlan-id
maxresponse
seconds
ip igmp snooping fast-
vlan-id
leave
ip igmp snooping
mcrtexpiretime
seconds
756
Configuring L2 Multicast Features
Purpose
Exit to Privileged EXEC mode.
View IGMP snooping settings configured on the switch.
View the IGMP snooping settings for a specific port or
LAG.
Purpose
Enter global configuration mode.
Enter VLAN Configuration mode.
vlan-id
Enable IGMP snooping on the specified VLAN.
Specify the host time-out value for the specified VLAN. If
an IGMP report for a multicast group is not received in
the number of seconds specified by the
VLAN is deleted from the member list of that multicast
group.
Specify the leave time-out value for the VLAN. If an
IGMP report for a multicast group is not received within
the number of seconds configured with this command
after an IGMP leave was received from a specific interface,
the current VLAN is deleted from the member list of that
multicast group.
Enables IGMP snooping fast-leave mode on the specified
VLAN. Enabling fast-leave allows the switch to
immediately remove the layer 2 LAN interface from its
forwarding table entry upon receiving an IGMP leave
message for that multicast group without first sending out
MAC-based general queries to the interface.
Specify the multicast router time-out value for to
vlan-id
associate with a VLAN. This command sets the number of
seconds to wait to age out an automatically-learned
multicast router port.
seconds
value, this