Managing the MAC Address Table (CLI)
This section provides information about the commands you use to manage
the MAC address table on the switch. For more information about the
commands, see the
Reference Guide
Managing the MAC Address Table
Beginning in Privileged EXEC mode, use the following commands to add a
static MAC address to the table, control the aging time for dynamic
addresses, and view entries in the MAC address table.
Command
configure
mac address-table static
mac-address
vlan
interface
interface
mac address-table aging-
time {0 | 10-1000000}
exit
show mac address-table
[static | dynamic]
852
Managing the MAC Address Table
PowerConnect M6220/M6348/M8024/M8024-k CLI
at support.dell.com/manuals.
Purpose
Enter global configuration mode.
Add a static MAC source address to the MAC address
vlan-id
table.
mac-address
•
xxxx.xxxx.xxxx.
vlan-id —
•
interface —
•
type and number.
Specify the number of seconds that must pass before an
unused dynamically-learned MAC address is removed from
the MAC address table. A value of 0 disables the aging
time for the MAC address table.
Exit to Privileged EXEC mode.
View information about the entries in the MAC address
table. Use the keywords static or dynamic to specify the
address type to view.
For dynamic entries, you can use the clear mac address-
table command to remove entries from the table.
— A valid MAC address in the format
A valid VLAN.
A valid port or LAG, including the interface