Configuring And Viewing Pim-Sm For Ipv6 Multicast Routing - Dell PowerEdge M420 Configuration Manual

Dell powerconnect m8024-k user's configuration guide

Hide thumbs Also See for PowerEdge M420:

Table of Contents

show ip pim rphash

show ip pim bsr

show ip pim rp mapping

Configuring and Viewing PIM-SM for IPv6 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to

configure PIM-SM for IPv6 multicast routing on the switch and on VLAN

routing interfaces and to view PIM-SM information.

ipv6 pim spt-threshold

ipv6 pim register-threshold

View the RP router being selected for the specified

multicast group address from the set of active RP

routers. The RP router for the group is selected by

using a hash algorithm.

View the bootstrap router (BSR) information.

View group-to-RP mappings of which the router is

aware (either configured or learned from the BSR)

Enter global configuration mode.

Enable PIM-SM as the multicast routing protocol on

Set the Data Threshold rate, in Kbps (range: 0–2000)

for the last-hop (or leaf) router to switch to the

shortest path.

Set the rate, in Kbps (range: 0–2000), above which the

Rendezvous Point router will switch to a source-

specific shortest path tree.

Managing IPv4 and IPv6 Multicast