Dell PowerEdge M420 Configuration Manual page 1218

Command
ip pim rp-address
group-address group-mask
[override]
ip pim ssm {default |
address group-mask
vlan-id
interface vlan
ip pim hello-interval
ip pim bsr-border
ip pim dr-priority
ip pim join-prune-interval
interval
exit
exit
show ip pim
show ip pim interface vlan
vlan-id
show ip pim neighbor
[interface vlan
1218
Managing IPv4 and IPv6 Multicast
Purpose
rp-address
(Optional) Statically configure the RP address for one
or more multicast groups. Only one RP address can be
used at a time within a PIM domain
The optional keyword override indicates that if there
is a conflict, the RP configured with this command
prevails over the RP learned by BSR.
group-
Define the Source Specific Multicast (SSM) range of
} IP multicast addresses.
• default — Defines the SSM range access list to
232.0.0.0/8.
group-address group-mask
•
Enter Interface Configuration mode for the specified
VLAN.
seconds
Specify the number of seconds (range: 0–65535) to
wait between sending PIM hello messages on the
interface.
Prevent bootstrap router (BSR) messages from being
sent or received through the interface.
priority
Set the priority value for which a router is elected as
the designated router (DR). The election priority
range is 0–2147483647.
Configure the interface join/prune interval for the
PIM-SM router. The interval range is 0–18000
seconds.
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View system-wide PIM-DM information.
View the PIM-SM information for the specified
interface.
View a summary or all the details of the multicast
vlan-id
| all] table.
— defines the SSM range.