Configuring IP Routing Features (CLI)
This section provides information about the commands you use to configure
IPv4 routing on the switch. For more information about the commands, see
PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide
Configuring Global IP Routing Settings
Beginning in Privileged EXEC mode, use the following commands to
configure various global IP routing settings for the switch.
ip icmp echo-reply
ip icmp error-interval
show ip brief
Enter global configuration mode.
Globally enable IPv4 routing on the switch.
Allow the switch to generate ICMP Echo Reply messages.
Limit the rate at which IPv4 ICMP error messages are sent.
initialized (Range: 0–2147483647 milliseconds).
can be sent during a burst interval (Range: 1–200).
Allow the switch to generate ICMP Redirect messages.
Configure the global default gateway for the switch. The
gateway configured here takes precedence over a default
gateway assigned by a network DHCP server.
Exit to Privileged EXEC mode.
View the global IP settings for the switch.
— How often the token bucket is
— The maximum number of messages that
Configuring IP Routing