Line Commands; Lldp Commands - Dell PowerConnect 3524 Cli Reference Manual

Line Commands

Command Group
line
speed
autobaud
exec-timeout
show line
terminal history
terminal history size

LLDP Commands

Command Group
lldp enable (global)
lldp enable (interface)
lldp timer
lldp hold-multiplier
lldp reinit-delay
lldp tx-delay
lldp optional-tlv
lldp management-
address
lldp med enable
lldp med network-
policy (global)
Description
Identifies a specific line for configuration and enters
the Line Configuration command mode.
Sets the line baud rate.
Sets the line for automatic baud rate detection.
Configures the interval that the system waits until
user input is detected.
Displays line parameters.
Enables the command history function for the
current terminal session.
Cand history buffer size for the current terminal
session.
Description
Enables Link Layer Discovery Protocol (LLDP).
Enables LLDP on an interface.
Specifies how often the software sends LLDP updates.
Specifies the amount of time the receiving device should
hold a LLDP packet before discarding it.
Specifies the minimum time an LLDP port will wait
before reinitializing LLDP transmission.
Specifies the delay between successive LLDP frame
transmissions initiated by value/status changes in the
LLDP local systems MIB.
Specifies which optional TLVs from the basic set should
be transmitted.
Specifies the management address that would be
advertised from an interface.
Enables LLDP Media Endpoint Discovery (MED) on an
interface.
Defines LLDP MED network policy.
Access Mode
Global Configuration
Line Configuration
Line Configuration
Line Configuration
User EXEC
User EXEC
User EXEC
Access Mode
Global configuration
Interface configuration
(Ethernet)
Global configuration
Global configuration
Global configuration
Global configuration
Interface configuration
(Ethernet)
Interface configuration
(Ethernet)
Interface configuration
(Ethernet)
Global configuration
Command Groups
45