Dell PowerConnect 3524 Cli Reference Manual page 347

port — Specifies the UDP port of the host to use. If unspecified, the default UDP port number is
•
162. (Range: 1 - 65535)
• filtername — Specifies a string that defines the filter for this host. If unspecified, nothing is
filtered. (Range: 1 - 30 characters)
• seconds — Specifies the number of seconds to wait for an acknowledgment before resending
informs. If unspecified, the default timeout period is 15 seconds.
(Range: 1 - 300)
• retries — Specifies the maximum number of times to resend an inform request, when a response is
not received for a generated message. If unspecified, the default maximum number of retries is 3.
(Range: 0 - 255)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• A user and notification view are not automatically created. Use the snmp-server user, snmp-server
group and snmp-server view Global Configuration mode commands to generate a user, group and
notify group, respectively.
• The IPv6Z address format: <ipv6-link-local-address>%<interface-name>
– interface-name — vlan<integer> | ch<integer> | isatap<integer> | <physical-port-name> | 0
– integer — <decimal-number> | <integer><decimal-number>
– decimal-number — 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9
– physical-port-name — Designated port number, for example 1/e16.
If the egress interface is not specified, the default interface is selected. Specifying interface zone=0 is
the same as not defining an egress interface.
Example
The following example configures an SNMPv3 host.
console(config)# snmp-server v3-host 192.168.0.20 john noauth
347
SNMP Commands