Port Monitor Commands
port monitor
The port monitor Interface Configuration Ethernet mode command starts a port monitoring
session. Use the no form of this command to stop a port monitoring session.
Syntax
•
port monitor src-interface [rx | tx]
•
no port monitor src-interface
•
src-interface — Valid Ethernet port. (Full syntax: unit/port)
•
rx — Monitors received packets only.
•
tx — Monitors transmitted packets only.
Default Configuration
Monitors both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
•
This command enables traffic on one port to be copied to another port, or between the source
port (src-interface) and a destination port (the port being configured). Only a single target port
can be defined per system.
•
The port being monitored cannot be set faster than the monitoring port.
Port Monitor Commands
295