speed
The speed Interface Configuration (Ethernet, port-channel) mode command configures the speed of a
given Ethernet interface when not using auto-negotiation. Use the no form of this command to restore
the default configuration.
Syntax
•
speed {10 | 100 | 1000}
•
10 — Forces 10 Mbps operation.
•
100 — Forces 100 Mbps operation.
•
1000 — Forces 1000 Mbps operation.
Default Configuration
Maximum port capability.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
•
There are no user guidelines for this command.
Example
The following example configures the speed operation of Ethernet port 1/e5 to 100 Mbps operation.
Console(config)# interface ethernet 1/e5
Console(config-if)# speed 100
duplex
The duplex Interface Configuration (Ethernet) mode command configures the full/half duplex
operation of a given Ethernet interface when not using auto-negotiation. Use the no form of this
command to restore the default configuration.
Syntax
•
duplex {half | full}
•
no duplex
•
half — Forces half-duplex operation
•
full — Forces full-duplex operation
166
Ethernet Configuration Commands