Clear Link Incident Alert(S) - HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual

Diagnostics
25
A link incident message appeared in the Link Incident Log or in the Link Incident
field of the Port Properties dialog box; or an event code 581, 582, 583, 584, 585, or
586 was observed at the console of an OSI server attached to the switch reporting the
problem.
Clear the link incident for the port.
a. At the Hardware View, right-click the port. A pop-up menu appears.
b. Select Clear Link Incident Alert(s). The Clear Link Incident Alert(s) dialog box
displays
Figure 2–15: Clear Link Incident Alert(s)
c. Select the This port (n) only radio button (where n is the port number) and click
OK. The link incident clears.
d. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
The problem is transient and the Fibre Channel link and switch appear
operational. Exit MAP.
26
Inspect the fiber-optic jumper cable attached to the port and ensure the cable is not
bent and connectors are not damaged. If the cable is bent or connectors are
damaged:
a. Notify the customer the port will be blocked. Ensure the customer's system
administrator quiesces Fibre Channel frame traffic through the port and sets the
attached device offline.
b. Block the port
c. Remove and replace the fiber-optic jumper cable.
d. Unblock the port
2–74
(Figure 2–15).
(Block and Unblock Ports on page
(Block and Unblock Ports on page
3–25).
3–25).
edge switch 2/24 service manual