HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 176

Messages
Message
Cannot show zoning
library. No fabric
exists.
Click OK to remove
all contents from log.
Connection to HAFM
server lost.
Connection to HAFM
server lost. Click OK
to exit application.
Could not export log
to file.
Default zoning is not
supported in Open
Fabric Mode.
A–6
Description
The user cannot
show the zoning
library if no fabric
exists. A Director or
Edge Switch must be
identified to the
HAFM application for
a fabric to exist.
This action deletes all
contents from the
selected log.
The connection to the
remote HAFM server
was lost.
The HAFM
application at a
remote workstation
lost the network
connection to the
HAFM server.
A log file input/output
(I/O) error occurred
and the file could not
be saved to the
specified destination.
The disk may be full
or write protected.
A default zone cannot
be enabled when the
switches in a fabric
are set to Open
Fabric mode.
Action
Identify a Director or Edge
Switch to the HAFM
application from the New
Product dialog box.
Click OK to delete the log
contents or Cancel to cancel
the operation.
Log in to the HAFM server
again through the HAFM
Login dialog box.
Start the HAFM application to
connect to the HAFM server.
If the disk is full, use another
disk. If the disk is write
protected, change the
write-protect properties or
use another disk.
Change the setting from
Open Fabric mode to
Homogeneous mode and
retry the default zoning
operation.
edge switch 2/24 service manual