HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 211

Message
System diagnostics
cannot run. The
Operational Status is
invalid.
The add firmware
process has been
aborted.
The data collection
process failed.
The data collection
process has been
aborted.
The following
parameters cannot
be disabled while
Enterprise Fabric
Mode is active:
Insistent Domain ID,
Rerouting Delay,
Domain RSCN's.
The maximum
number of address
configurations has
been reached.
The optical
transceiver is not
installed.
edge switch 2/24 service manual
Description
System diagnostics
cannot run on switch
or Director or Edge
Switch with failed
ports.
The user aborted the
process to add a
firmware version to
the HAFM server's
firmware library.
An error occurred
while performing the
data collection
procedure.
The user aborted the
data collection
procedure.
A user attempted to
disable one or more
of these parameters
at the Configure
Switch Parameters
dialog box with the
switch online and
Enterprise Fabric
Mode (SANtegrity
feature) enabled.
The maximum
number of address
configurations that
can be saved to the
HAFM server was
reached.
Information is not
available for a port
without an optical
transceiver installed.
Action
Replace failed ports.
Verify the firmware addition is
to be aborted, then click OK
to continue.
Try the data collection
procedure again. If the
problem persists, contact the
next level of support.
Verify the data collection
procedure is to be aborted,
then click OK to continue.
Click Yes to continue and
disable Enterprise Fabric
Mode.
Delete configurations no
longer needed to allow one or
more new address
configurations to be saved.
Install an SFP optical
transceiver in the port.
Messages
A–41