Fru Removal And Replacement; Procedural Notes; Remove And Replace Frus - HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual

This chapter describes the removal and replacement procedures (RRPs) for the HP
StorageWorks Edge Switch 2/24 field-replaceable units (FRUs). Do not remove a FRU
until a failure is isolated to that FRU. If fault isolation was not performed, see
0000: Start MAP on page

Procedural Notes

Note the following:
1. Read the removal and replacement procedures (RRPs) for that FRU before
removing the FRU.
2. Follow all WARNING and CAUTION statements and statements in the preface
of this manual.
3. After completing a FRU replacement, clear the event code reporting the failure
and the event code reporting the recovery from the switch Event Log (at the
HAFM server). Extinguish the amber system error (ERR) light-emitting diode
(LED) at the switch front panel.

Remove and Replace FRUs

This section describes procedures to remove and replace concurrent switch FRUs,
along with tools required to perform each procedure. Concurrent FRUs are removed
and replaced while the switch is powered on and operational.
edge switch 2/24 service manual
Invisible

FRU Removal and Replacement

2–6.
4
Body4
MAP
4–1