Creating A Local Span Session And Configuring Incoming Traffic - Cisco IE-4000 Software Configuration Manual

Configuring SPAN and RSPAN
How to Configure SPAN and RSPAN
Command
4. monitor session session_number
destination {interface interface-id [, | -]
[encapsulation replicate]}
5. end

Creating a Local SPAN Session and Configuring Incoming Traffic

Command
1. configure terminal
2. no monitor session {session_number | all |
local | remote}
Purpose
Specifies the SPAN session and the destination port (monitoring
port).
session_number—Specifies the session number entered in step 3.
Note: For local SPAN, you must use the same session number for the
source and destination interfaces.

interface-id—Specifies the destination port. The destination
interface must be a physical port; it cannot be an EtherChannel,
and it cannot be a VLAN.

(Optional) [, | -]—Specifies a series or range of interfaces. Enter
a space before and after the comma; enter a space before and
after the hyphen.

(Optional) encapsulation replicate—Specifies that the
destination interface replicates the source interface
encapsulation method. If not selected, the default is to send
packets in native form (untagged).
Note: You can use monitor session session_number destination
command multiple times to configure multiple destination ports.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Removes any existing SPAN configuration for the session.
476