Protocol Vlan Group All; Vlan Pvid; Vlan Tagging - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

6.1.20 protocol vlan group all

This command adds all physical interfaces to the protocol-based VLAN identified by
. You can associate multiple interfaces with a group, but you can only associate
<groupid>
each interface and protocol combination with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command will
fail and the interface(s) will not be added to the group.
Create the referenced VLAN before you create the protocol-based VLAN except when
you configure GVRP to create the VLAN.
Format
Mode
6.1.20.1 no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is
identified by this
Format
Mode

6.1.21 vlan pvid

This command changes the VLAN ID per interface.
Default
Format
Mode
6.1.21.1 no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
Mode

6.1.22 vlan tagging

This command configures the tagging behavior for a specific interface in a VLAN to
enabled. If tagging is enabled, traffic is transmitted as tagged frames. If tagging is
disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
VLAN Commands
protocol vlan group all <groupid>
Global Config
.
<groupid>
no protocol vlan group all <groupid>
Global Config
1
vlan pvid <1-4094>
Interface Config
no vlan pvid
Interface Config
v1.0, March 2006
6-9