Flowcontrol - SMC Networks 6824MPE INT Management Manual

Example
The following example configures Ethernet port 5 capabilities to 100half,
100full and flow control.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#
Related Commands
negotiation (4-177)
speed-duplex (4-175)

flowcontrol (4-179)

flowcontrol
Use this command to enable flow control. Use the no form to disable flow
control.
Syntax
[no] flowcontrol
Default Setting
Flow control enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Flow control can eliminate frame loss by "blocking" traffic from end
stations or segments connected directly to the switch when its buffers
fill. When enabled, back pressure is used for half-duplex operation and
IEEE 802.3x for full-duplex operation.
• To force flow control on or off (with the flowcontrol or no flowcontrol
command), use the no negotiation command to disable
auto-negotiation on the selected interface.
I C
NTERFACE OMMANDS
4-179