Configuring General Dns Server Parameters - SMC Networks 6824MPE INT Management Manual

You can manually configure entries in the DNS table used for mapping
domain names to IP addresses, configure default domain names, or specify
one or more name servers to use for domain name to address translation.

Configuring General DNS Server Parameters

Command Usage
• To enable DNS service on this switch, first configure one or more
name servers, and then enable domain lookup status.
• To append domain names to incomplete host names received from a
DNS client (i.e., not formatted with dotted notation), you can specify
a default domain name or a list of domain names to be tried in
sequential order.
• If there is no domain list, the default domain name is used. If there is
a domain list, the default domain name is not used.
• When an incomplete host name is received by the DNS server on this
switch and a domain name list has been specified, the switch will work
through the domain list, appending each domain name in the list to the
host name, and checking with the specified name servers for a match.
• When more than one name server is specified, the servers are queried
in the specified sequence until a response is received, or the end of the
list is reached with no response.
• Note that if all name servers are deleted, DNS will automatically be
disabled.
Command Attributes
• Domain Lookup Status – Enables DNS host name-to-address
translation.
• Default Domain Name* – Defines the default domain name
appended to incomplete host names. (Range: 1-64 alphanumeric
characters)
• Domain Name List* – Defines define a list of domain names that can
be appended to incomplete host names. (Range: 1-64 alphanumeric
characters. 1-5 names)
C D
ONFIGURING
N S
OMAIN AME ERVICE
3-207