Configuring Lacp Parameters - SMC Networks 6824MPE INT Management Manual

24-port fast ethernet poe switch
Hide thumbs Also See for 6824MPE INT:
Table of Contents

Advertisement

C
ONFIGURING THE
CLI – The following example enables LACP for ports 1 to 6. Just connect
these ports to LACP-enabled trunk ports on another switch to form a
trunk.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type: 1000T
Mac address: 22-22-22-22-22-2d
Configuration:
Name:
Port admin status: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full,
Flow control status: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Combo forced mode: None
Current status:
Created by: Lacp
Link status: Up
Port operation status: Up
Operation speed-duplex: 1000full
Flow control type: None
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#

Configuring LACP Parameters

Dynamically Creating a Port Channel
Ports assigned to a common port channel must meet the following criteria:
Ports must have the same LACP System Priority.
Ports must have the same LACP port Admin Key.
However, if the "port channel" Admin Key is set (
port Admin Key must be set to the same value for a port to be allowed
to join a channel group.
3-114
S
WITCH
4-174
4-195
4-183
), then the
page 4-199

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6824MPE INT and is the answer not in the manual?

This manual is also suitable for:

Tigerstack iii smc6824mpe

Table of Contents