GVRP and Bridge Extension Commands
GARP VLAN Registration Protocol defines a way for switches to exchange
VLAN information in order to automatically register VLAN members on
interfaces across the network. This section describes how to enable GVRP
for individual interfaces and globally for the switch, as well as how to display
default configuration settings for the Bridge Extension MIB.
Command
bridge-ext gvrp
show bridge-ext
switchport gvrp
switchport forbidden vlan Configures forbidden VLANs for an
show gvrp configuration
garp timer
show garp timer
bridge-ext gvrp
Use this command to enable GVRP globally for the switch. Use the no form
to disable it.
Syntax
[no] bridge-ext gvrp
Default Setting
Disabled
Command Mode
Global Configuration
Table 4-58 GVRP and Bridge Extension Commands
Function
Enables GVRP globally for the switch GC
Shows the global bridge extension
configuration
Enables GVRP for an interface
interface
Displays GVRP configuration for
selected interface
Sets the GARP timer for the selected
function
Shows the GARP timer for the
selected function
GVRP
B
AND
RIDGE
E
C
XTENSION
OMMANDS
Mode Page
PE
IC
IC
NE,
PE
IC
NE,
PE
4-239
4-240
4-241
4-236
4-241
4-242
4-243
4-239
Need help?
Do you have a question about the 6824MPE INT and is the answer not in the manual?