Spanning-Tree Edge-Port - SMC Networks 6824MPE INT Management Manual

24-port fast ethernet poe switch
Hide thumbs Also See for 6824MPE INT:
Table of Contents

Advertisement

Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 0
Console(config-if)#
Related Commands
spanning-tree cost (4-218)

spanning-tree edge-port

Use this command to specify an interface as an edge port. Use the no form
to restore the default.
Syntax
[no] spanning-tree edge-port
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• You can enable this option if an interface is attached to a LAN segment
that is at the end of a bridged LAN or to an end node. Since end nodes
cannot cause forwarding loops, they can pass directly through to the
spanning tree forwarding state. Specifying Edge Ports provides quicker
convergence for devices such as workstations or servers, retains the
current forwarding database to reduce the amount of frame flooding
required to rebuild address tables during reconfiguration events, does
not cause the spanning tree to initiate reconfiguration when the interface
changes state, and also overcomes other STA-related timeout problems.
However, remember that Edge Port should only be enabled for ports
connected to an end-node device.
• This command has the same effect as the spanning-tree portfast.
S
T
PANNING
REE
C
OMMANDS
4-221

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6824MPE INT and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Tigerstack iii smc6824mpe

Table of Contents