Queue Mode; Table 4-60 Priority Commands (Layer 2) - SMC Networks 6824MPE INT Management Manual

Priority Commands (Layer 2)
Command

queue mode

switchport priority
default
queue bandwidth
queue cos map
show queue
bandwidth
show queue cos-map Shows the class-of-service map
show interfaces
switchport
queue mode
This command sets the queue mode to strict priority or Weighted
Round-Robin (WRR) for the class of service (CoS) priority queues. Use the
no form to restore the default value.
Syntax
queue mode {strict | wrr}
no queue mode
• strict - Services the egress queues in sequential order, transmitting all
traffic in the higher priority queues before servicing lower priority
queues.
• wrr - Weighted Round-Robin shares bandwidth at the egress ports by
using scheduling weights 1, 2, 4, 6, 8, 10, 12, 14 for queues 0 - 7
respectively.
Default Setting
Weighted Round Robin

Table 4-60 Priority Commands (Layer 2)

Function
Sets the queue mode to strict priority or
Weighted Round-Robin (WRR)
Sets a port priority for incoming untagged
frames
Assigns round-robin weights to the priority
queues
Assigns class-of-service values to the priority
queues
Shows round-robin weights assigned to the
priority queues
Displays the administrative and operational
status of an interface
P C
RIORITY OMMANDS
Mode Page
GC
IC
GC
IC
PE
PE
PE
4-245
4-247
4-246
4-247
4-248
4-250
4-250
4-186