Glossary - SMC Networks 6824MPE INT Management Manual

Access Control List (ACL)
ACLs can limit network traffic and restrict access to certain users or devices by
checking each packet for certain IP or MAC (i.e., Layer 2) information.
Address Resolution Protocol (ARP)
ARP converts between IP addresses and MAC (i.e., hardware) addresses. ARP is
used to locate the MAC address corresponding to a given IP address. This allows
the SMC6824MPE switch to use IP addresses for routing decisions and the
corresponding MAC addresses to forward packets from one hop to the next.
Boot Protocol (BOOTP)
BOOTP is used to provide bootup information for network devices, including IP
address information, the address of the TFTP server that contains the devices
system files, and the name of the boot file.
Class of Service (CoS)
CoS is supported by prioritizing packets based on the required level of service, and
then placing them in the appropriate output queue. Data is transmitted from the
queues using weighted round-robin service to enforce priority service and prevent
blockage of lower-level queues. Priority may be set according to the port default,
the packet's priority bit (in the VLAN tag), TCP/UDP port number, IP Precedence
bit, or DSCP priority bit.
Differentiated Services Code Point Service (DSCP)
DSCP uses a six-bit tag to provide for up to 64 different forwarding behaviors.
Based on network policies, different kinds of traffic can be marked for different
kinds of forwarding. The DSCP bits are mapped to the Class of Service categories,
and then into the output queues.
Domain Name Service (DNS)
A system used for translating host names for network nodes into IP addresses.
G
LOSSARY

Glossary-1