Switchport Priority Default - SMC Networks 6824MPE INT Management Manual

C L
OMMAND INE
Command Mode
Global Configuration
Command Usage
You can set the switch to service the queues based on a strict rule that
requires all traffic in a higher priority queue to be processed before lower
priority queues are serviced, or use Weighted Round-Robin (WRR)
queuing that specifies a relative weight of each queue. WRR uses a
predefined relative weight for each queue that determines the percentage
of service time the switch services each queue before moving on to the
next queue. This prevents the head-of-line blocking that can occur with
strict priority queuing.
Example
The following example sets the queue mode to strict priority service mode:
Console(config)#queue mode strict
Console(config)#

switchport priority default

Use this command to set a priority for incoming untagged frames. Use the
no form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames received
on the interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
4-246
I
NTERFACE