Show Map Ip Port - SMC Networks 6824MPE INT Management Manual

• This command sets the IP DSCP priority for all interfaces.
Example
The following example shows how to map IP DSCP value 1 to CoS value 0:
Console(config)#interface ethernet 1/5
Console(config-if)#map ip dscp 1 cos 0
Console(config-if)#

show map ip port

Use this command to show the IP port priority map.
Syntax
show map ip port [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
None
Command Mode
Privileged Exec
Example
The following shows that HTTP traffic has been mapped to CoS value 0.
Console#show map ip port
TCP port mapping status: disabled
Port
--------- -------- ---
Eth 1/ 5
Console#
Related Commands
map ip port (Global Configuration) (4-252)
Port no. COS
80 0
P C
RIORITY OMMANDS
4-257