Figure 3-12 Setting The Startup Configuration Settings - SMC Networks 6824MPE INT Management Manual

If you download to a new file name using "tftp to startup-config" or "tftp
to file," the file is automatically set as the start-up configuration file. To use
the new settings, reboot the system via the System/Reset menu.
Note that you can also select any configuration file as the start-up
configuration by using the System/File/Set Start-Up page.

Figure 3-12 Setting the Startup Configuration Settings

CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
Console#copy tftp startup-config
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
To select another configuration file as the start-up configuration, use the
boot system command and then restart the switch.
Console(config)#boot system config: startup-new
Console(config)#exit
Console#reload
B C
ASIC ONFIGURATION
4-84
4-91
4-31
3-27