Gvrp And Bridge Extension Commands; Bridge-Ext Gvrp - SMC Networks 6128PL2 - annexe 2 Management Manual

4
Command Line Interface

GVRP and Bridge Extension Commands

GARP VLAN Registration Protocol defines a way for switches to exchange VLAN
information in order to automatically register VLAN members on interfaces across
the network. This section describes how to enable GVRP for individual interfaces
and globally for the switch, as well as how to display default configuration settings
for the Bridge Extension MIB.
Command

bridge-ext gvrp

show bridge-ext
switchport gvrp
switchport forbidden vlan
show gvrp configuration
garp timer
show garp timer
bridge-ext gvrp
This command enables GVRP globally for the switch. Use the no form to disable it.
Syntax
[no] bridge-ext gvrp
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
GVRP defines a way for switches to exchange VLAN information in order to
register VLAN members on ports across the network. This function should be
enabled to permit automatic VLAN registration, and to support VLANs which
extend beyond the local switch.
Example
Console(config)#bridge-ext gvrp
Console(config)#
4-220
Table 4-62 GVRP and Bridge Extension Commands
Function
Enables GVRP globally for the switch
Shows the global bridge extension configuration
Enables GVRP for an interface
Configures forbidden VLANs for an interface
Displays GVRP configuration for the selected interface NE, PE
Sets the GARP timer for the selected function
Shows the GARP timer for the selected function
Mode Page
GC 4-220
PE 4-221
IC 4-221
IC 4-231
4-222
IC 4-222
NE, PE 4-223