Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Command
interface
description
speed-duplex
negotiation
capabilities
flowcontrol
shutdown
clear counters
show interfaces status Displays status for the specified
show interfaces
counters
show interfaces
switchport
Table 4-42 Interface Commands
Function
Configures an interface type and
enters interface configuration mode
Adds a description to an interface
configuration
Configures the speed and duplex
operation of a given interface when
autonegotiation is disabled
Enables autonegotiation of a given
interface
Advertises the capabilities of a given
interface for use in autonegotiation
Enables flow control on a given
interface
Disables an interface
Clears statistics on an interface
interface
Displays statistics for the specified
interfaces
Displays the administrative and
operational status of an interface
I
C
NTERFACE
OMMANDS
Mode
GC
IC
IC
IC
IC
IC
IC
PE
NE, PE
NE, PE
NE, PE
Page
4-146
4-146
4-147
4-148
4-149
4-150
4-151
4-152
4-153
4-154
4-156
4-145
Need help?
Do you have a question about the 6152L2 - annexe 1 and is the answer not in the manual?
Questions and answers