Interface Commands - SMC Networks 8748L2 Management Manual

Interface Commands

These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Command
interface
description
speed-duplex
negotiation
capabilities
flowcontrol
shutdown
switchport broadcast
packet-rate
clear counters
show interfaces status Displays status for the specified
show interfaces
counters
show interfaces
switchport
Table 4-38 Interface Commands
Function
Configures an interface type and
enters interface configuration mode
Adds a description to an interface
configuration
Configures the speed and duplex
operation of a given interface when
autonegotiation is disabled
Enables autonegotiation of a given
interface
Advertises the capabilities of a given
interface for use in autonegotiation
Enables flow control on a given
interface
Disables an interface
Configures the broadcast storm
control threshold
Clears statistics on an interface
interface
Displays statistics for the specified
interfaces
Displays the administrative and
operational status of an interface
I C
NTERFACE OMMANDS
Mode
GC
IC
IC
IC
IC
IC
IC
IC
PE
NE, PE
NE, PE
NE, PE
Page
4-132
4-132
4-133
4-134
4-135
4-136
4-137
4-138
4-139
4-140
4-141
4-143
4-131