SMC Networks 6152L2 - annexe 1 Management Manual page 566

T
ROUBLESHOOTING
Symptom
Cannot connect using
Secure Shell
Cannot access
the on-board
configuration
program via a serial
port connection
Forgot or lost the
password
B-2
Table B-1 Troubleshooting Chart (Continued)
Action
• If you cannot connect using SSH, you may have exceeded
the maximum number of concurrent Telnet/SSH sessions
permitted. Try connecting again at a later time.
• Be sure the control parameters for the SSH server are
properly configured on the switch, and that the SSH client
software is properly configured on the management station.
• Be sure you have generated a public key on the switch, and
exported this key to the SSH client.
• Be sure you have set up an account on the switch for each
SSH user, including user name, authentication level, and
password.
• Be sure you have imported the client's public key to the
switch (if public key authentication is used).
• Be sure you have set the terminal emulator program to
VT100 compatible, 8 data bits, 1 stop bit, no parity, and the
baud rate set to any of the following (9600, 19200, 38400,
57600, 115200 bps).
• Check that the null-modem serial cable conforms to the
pin-out connections provided in the Installation Guide.
• Contact SMC Technical Support for help.