SMC Networks 6152L2 - annexe 1 Management Manual page 66

Tigerswitch 10/100 48-port 10/100 mbps fast ethernet managed switch
Hide thumbs Also See for 6152L2 - annexe 1:
Table of Contents

Advertisement

C
ONFIGURING THE
IP Address Mode – Specifies whether IP functionality is enabled via
manual configuration (Static), Dynamic Host Configuration Protocol
(DHCP), or Boot Protocol (BOOTP). If DHCP/BOOTP is enabled,
IP will not function until a reply has been received from the server.
Requests will be broadcast periodically by the switch for an IP address.
(DHCP/BOOTP values can include the IP address, subnet mask, and
default gateway.)
IP Address – Address of the VLAN interface that is allowed
management access. Valid IP addresses consist of four numbers, 0 to
255, separated by periods. (Default: 0.0.0.0)
Subnet Mask – This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.255.255.0)
Gateway IP Address – IP address of the gateway router between this
device and management stations that exist on other network segments.
(Default: 0.0.0.0)
MAC Address – The physical layer address for this switch.
Restart DHCP – Requests a new IP address from the DHCP server.
3-20
S
WITCH

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6152L2 - annexe 1 and is the answer not in the manual?

This manual is also suitable for:

Tigerswitch smc6152l2

Table of Contents