Figure 3-10. Setting The Startup Code; Figure 3-11. Deleting Files - SMC Networks 6152L2 - annexe 1 Management Manual

C
ONFIGURING THE
If you download to a new destination file, go to the System, File
Management, Set Start-Up menu, mark the operation code file used at
startup, and click Apply. To start the new firmware, reboot the system via
the System/Reset menu.
To delete a file select System, File Management, Delete. Select the file
name from the given list by checking the tick box and click Apply. Note
that the file currently designated as the startup code cannot be deleted.
CLI – Enter the IP address of the TFTP server, select "config" or
"opcode" file type, then enter the source and destination file names, set the
new file to start up the system, and then restart the switch.
.
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config:
Source file name: v1000-18.bix
Destination file name: V1.0
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system opcode:V1.0
Console(config)#exit
Console#reload
3-26
S
WITCH

Figure 3-10. Setting the Startup Code

Figure 3-11. Deleting Files

2. opcode: <1-2>: 2
4-84
4-90
4-30