Filtering Management Access - SMC Networks 6152L2 - annexe 1 Management Manual

C
ONFIGURING THE
CLI – This examples assigns an IP access list to port 1, and an IP access
list to port 2.
Console(config)#interface ethernet 1/1
Console(config-if)#ip access-group david in
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#ip access-group david in
Console(config-if)#

Filtering Management Access

You can specify the client IP addresses that are allowed management
access to the switch through the web interface, SNMP, or Telnet.
Command Usage
• The management interfaces are open to all IP addresses by default.
Once you add an entry to a filter list, access to that interface is
restricted to the specified addresses.
• If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
• IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
• You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or
by specifying both the start address and end address.
3-106
S
WITCH
4-146
4-119