System Log Configuration; Figure 3-16. Displaying Logs - SMC Networks 6152L2 - annexe 1 Management Manual

Web – Click System, Log, Logs.
CLI – This example shows the event message stored in RAM.
Console#show log ram
[1] 00:01:37 2001-01-01
"DHCP request failed - will retry later."
level: 4, module: 9, function: 0, and event no.: 10
[0] 00:00:35 2001-01-01
"System coldStart notification."
level: 6, module: 6, function: 1, and event no.: 1
Console#

System Log Configuration

The system allows you to enable or disable event logging, and specify
which levels are logged to RAM or flash memory.
Severe error messages that are logged to flash memory are permanently
stored in the switch to assist in troubleshooting network problems. Up to
4096 log entries can be stored in the flash memory, with the oldest entries
being overwritten first when the available log memory (256 kilobytes) has
been exceeded.
The System Logs page allows you to configure and limit system messages
that are logged to flash or RAM memory. The default is for event levels 0
to 3 to be logged to flash and levels 0 to 6 to be logged to RAM.

Figure 3-16. Displaying Logs

B C
ASIC ONFIGURATION
4-64
3-35