SMC Networks 6152L2 - annexe 1 Management Manual page 405

Command
show ip access-list
ip access-group
show ip
access-group
map access-list ip
show map
access-list ip
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the
source IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• An egress ACL must contain all deny rules.
• When you create a new ACL or enter configuration mode for an
existing ACL, use the permit or deny command to add new rules to
Table 4-34 IP ACL Commands (Continued)
Function
Displays the rules for configured IP
ACLs
Adds a port to an IP ACL
Shows port assignments for IP ACLs
Sets the CoS value and corresponding
output queue for packets matching an
ACL rule
Shows CoS value mapped to an access
list for an interface
A C
CCESS ONTROL
L C
IST OMMANDS
Mode Page
PE 4-118
IC 4-119
PE 4-119
IC 4-120
PE 4-121
4-115