Interface Commands - SMC Networks 8708L2 - annexe 1 Management Manual

Interface Commands

These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Command
interface
description
speed-duplex
negotiation
capabilities
shutdown
switchport
broadcast
packet-rate
clear counters
show interfaces
status
show interfaces
counters
show interfaces
switchport
* This command is not supported.
Table 4-44 Interface Commands
Function
Configures an interface type and enters
interface configuration mode
Adds a description to an interface
configuration
Configures the speed and duplex operation of
*
a given interface when autonegotiation is
disabled
Enables autonegotiation of a given interface
*
Advertises the capabilities of a given interface
*
for use in autonegotiation
Disables an interface
Configures the broadcast storm control
threshold
Clears statistics on an interface
Displays status for the specified interface
Displays statistics for the specified interfaces NE,
Displays the administrative and operational
status of an interface
I C
NTERFACE OMMANDS
Mode Page
GC
IC
IC
IC
IC
IC
IC
PE
NE,
PE
PE
NE,
PE
4-170
4-170
4-171
4-172
4-173
4-174
4-175
4-176
4-177
4-178
4-180
4-169