Table 4-72 Switch Cluster Commands - SMC Networks 6152L2 - annexe 1 Management Manual

Command
cluster
cluster
commander
cluster ip-pool
cluster member
rcommand
show cluster
show cluster
members
show cluster
candidates
cluster
This command enables clustering on the switch. Use the no form to
disable clustering.
Syntax
[no] cluster
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• To create a switch cluster, first be sure that clustering is enabled on the
switch (the default is enabled), then set the switch as a Cluster
Commander. Set a Cluster IP Pool that does not conflict with any
other IP subnets in the network. Cluster IP addresses are assigned to
switches when they become Members and are used for
communication between Member switches and the Commander.

Table 4-72 Switch Cluster Commands

Function
Configures clustering on the switch
Configures the switch as a cluster
Commander
Sets the cluster IP address pool for
Members
Sets Candidate switches as cluster members GC
Provides configuration access to Member
switches
Displays the switch clustering status
Displays current cluster Members
Displays current cluster Candidates in the
network
S C
WITCH LUSTER
Mode Page
GC
GC
GC
GC
PE
PE
PE
C
OMMANDS
4-256
4-258
4-259
4-260
4-261
4-262
4-263
4-263
4-265